3
4
3. Place the mount on the floor.
Using the power drill and the 7/32” drill bit, drill into the pencil
marks as shown.
Ensure you are drilling into the studs.
Drill
each hole about 2” into the stud.
4. Remove
4 lag bolts
and
4 large washers
from the pouch
labeled
LAG
.
Place the mount against the wall, and use a wrench to insert the
lag bolts and washers into the holes you just drilled. You can
make small adjustments before inserting the lag bolts completely.
The mount is attached to the wall.
Go to Step 4 on page 8.
7/32”
2
1
3
4
Pencil Marks
5
