VMA13-32 / VMT13-32
Installation Instructions
Page 5
Backplate Installation - Wood Stud
NOTE
:
These installation instructions will apply to the VMA13-32 / VMT13-32 Swingout Arm and
the Tilt/Pivot Mount.
The following steps will outline how the back plate will be mounted.
1.
Determine where the mount location will be.
2.
Use a stud finder (sold separately) to locate the nearest wall stud.
3.
Once the wall stud has been located, dead-center of the wall stud must be determined.
4.
After this has been determined, line-up the holes of the backplate.
NOTE
: Be sure that the end of the back plate that has a “lip” is pointing down (Figure 1).
5.
Use the provided wood screws to attach the back plate to the wall (Figure 2).
Figure 1
. Backplate Mount
Figure 2
. Backplate Installation
