Vivotek ND9322P-v2, Руководство пользователя

Страница: 30 / 200

VIVOTEK - Built with Reliability
30 - User's Manual
To power up and power down,
On the initial configuration:
1. Connect the power cord between the system and power outlet.
2. Turn on the system using the power button on the back of chassis.
After the initial connection,
Use the power down button on the lower right corner of the Settings page. The system
should start flushing the cached contents in system memory and gracefully shut down. You
should then flip the power switch button on the back of chassis to completely shut down the
system.
Press the Reset button for longer than 5 seconds can restore system defaults.
Power Up and Power Down
1. No storage system is completely fail-safe. Damage to data might occur due to file system
corruption, operating system malfunction, virus infection, HDD component failures, and so on.
Therefore, it is highly recommended to regularly back up your data, and VIVOTEK disclaims
responsibilities of data loss or recovery.
2. Always power off the system using the power button on the back of chassis. The system is
powered off when you observe that all LEDs go off. Do not disconnect the power cord while
the system is still operating. Doing so will result in data inconsistencies. The normal power-off
procedure allows cached data to be written to disks.
If system buzzer is sounded, move your mouse cursor to reveal the main screen portal, and
then click on the Stop buzzer button.
Serious system faults, such as a missing volume, can trigger the system buzzer. Verify the
cause of system fault and turn off the buzzer.
NOTE:
WARNING:
6