VIVOTEK
User's Manual - 5
Hardware Installation
IMPORTANT:
The diameters of the cable holes on the rubber seal
are shown on the right. Please properly install the
waterproof cable gland and cables through it to obtain
IP66 waterproof functionality.
All units are in millimeters. The cable range for the
Ethernet cable is 6.4 to 4.3mm, 1.6mm for DI lines.
1
2
3
4
M
icro
SD
5
1. Open the camera's rear cover.
2. Loosen the hex socket screws on the sides of the bracket.
3. Disassemble the waterproof connector. Pass a CAT5e cable through the rubber seal inside
as shown below. Re-assemble the waterproof connector. Connect the RJ45 connector in the
camera chassis, and then secure the rear cover. You can also power the camera using 2 DC
lines to the terminal connector.
4. Install the SD card, and replace the desiccant bag attached to the inner wall of the canister.
5. Loosen and remove the hex screw on the mount bracket, so that the other end of the Ethernet
cable can pass through the bracket.