181
Specify a period of the time the client has to wait before the next re-authentication attempt.
This will prevent the Switch from becoming overloaded with continuous re-authentication
attempts from the client. The acceptable range for this field is 0 to 65535 seconds.
Server Timeout:
The server-timeout value is used for timing out the Authentication Server.
Supp-Timeout:
The supp-timeout value is the initialization value used for timing out a Supplicant.
Max-req Time:
Specify the amount of times the Switch will try to connect to the authentication server before
determining the server is down. The acceptable range for this field is 1 to 10 times.
Default Settings
The default global 802.1x state is disabled.
The default 802.1x Authentication Method is local.
The default port 802.1x state is disabled for all ports.
The default port Admin Control Direction is both for all ports.
The default port Re-authentication is disabled for all ports.
The default port Control Mode is auto for all ports.
The default port Guest VLAN is 0 for all ports. (Guest VLAN is disabled).
The default port Max-req Time is 2 times for all ports.
The default port Reauth period is 3600 seconds for all ports.
The default port Quiet period is 60 seconds for all ports.
The default port Supp timeout is 30 seconds for all ports.
The default port Server timeout is 30 seconds for all ports.
7.3.2.
CLI Configuration
Node
Command
Description
enable
show dot1x
This command displays the current 802.1x
configurations.
enable
show dot1x username
This command displays the current user accounts for the
local authentication.
enable
show dot1x
accounting-record
This command displays the local accounting records.
configure dot1x authentication
(disable|enable)
This
command
enables/disables
the
802.1x
authentication on the switch.
configure dot1x authentic-
method (local|radius)
This command configures the authentic method of
802.1x.
configure no dot1x authentic-
method
This command configures the authentic method of
802.1x to default.
configure dot1x radius primary-
server-ip <IP> port
PORTID
This command configures the primary radius server.
configure dot1x radius primary-
This command configures the primary radius server.
