Vivotek AE2000, Руководство пользователя

Страница: 4 / 64

4
Power connection III.
Please refer to the wiring diagram as below.
10
D/N trigger signal
Red
Orange
Black
Red wire: +5Vdc
Orange wire: 0Vdc
Black wire: Ground
IR Control Board
A: If IR trigger signal is on the high position
(+5Vdc), connect the Red and Black
wire to D/N trigger line +/- of camera.
B: If IR trigger signal is on the Low position
(+0Vdc), connect the Orange and Black
wire to D/N trigger line +/- of camera.
When using two-cord power cable, please connect them to “Live” and “Neutral”.
L E N
Neutral (Blue Wire)
Earth (Yellow/Green Wire)
Live (Brown Wire)
AC 24V Adapter
External Power Input Connection
Hardware installation IV.
1
2
Side View
Zoom ring
Focus ring
L-type hex key wrench
1. Loosen two screws on both sides of the camera bracket, and then adjust the position of
camera bracket by sliding it up and down.
2. Use the supplied L-type hex key wrench to fix the camera on the camera bracket.
3. Connect the power cable and Ethernet cable to the camera.
AE2000_Manual_VVTK_20080806.indd 4 2008/8/7 上午 10:52:27