ENGLISH
THANKS FOR CHOOSING ONE OF OUR PRODUCTS
Mounting the Wall Plate to the Wall
Insert the Locking Bar and attach the Monitor to Wall Plate
Step 2
Step 3
Warning: Some monitors may require two people to lift!
Insert the Locking Bar (c) to the Wall Plate (a) as shown in the Diagram 3a. If necessary add a padlock (not
supplied) at the end of the locking bar. Hook the Monitor Brackets (b) over the top of the Wall Plate (a) and
then let the bottom of the Monitor Brackets rotate to the bottom of the
Wall Plate as shown in the Diagram 3b. Push the bottom of the monitor
to lock the Monitor Brackets on the Wall Plate, as shown in the Diagram
3c. Pull out the Locking Bar first if you want to remove the monitor from
the Wall Plate.
Wood Stud mounting:
The Wall Plate (a) must be mounted to two studs at least 16” (406 mm)
apart. Use a stud finder to locate two adjacent studs. It is a good idea
to verify where the studs are located with an awl or thin nail. Pre-drill a
50 mm deep hole at the desired height in each stud using a 4 mm drill
bit. Make sure these holes are in the center area of the studs and level
with each other. Use the Wall Plate as a template to mark the location
of the second hole in each stud. Drill 50 mm deep holes using the 3.8
mm drill bit in the marked locations. Attach the Wall Plate to the wall
using the 4 Lag Bolts (n) and 4 Lag Bolt Washers (o).
8
n
o
a
c
a
b
a
3a
3b
3c
