10
If you do not understand these directions, or if you have any doubts about the safety of the installation,
please call a qualified technician. Check carefully to make sure there are no missing or defective parts.
Improper installation may cause damage or serious injury. Do not use this product for any purpose that is
not explicitly specified in this manual and do not exceed weight capacity. We cannot be liable for damage
or injury caused by improper mounting, incorrect assembly, or inappropriate use.
WARNING!
REMOTE CONTROL OPERATING INSTRUCTIONS
Install two AAA batteries (not included) in the remote. Plug the mount in. The mount will beep once. Use
a pencil or other thin tool to press the button on the front of the mount’s control unit, then press the SET
button on the remote. The control unit will beep repeatedly for about 10 seconds. The mount is ready for
operation when the beeping stops.
UPWARD/DOWNWARD MOVEMENT
Press and hold the up button to raise the TV. Press and hold the down button to lower the TV.
SAVE AND RECALL MEMORY
To save a certain location to memory, press and hold the “mem1” or “mem2” button for 3 seconds. The
mount will beep, indicating the position has been saved to memory. To recall memory locations, press
the ( 1 ) or ( 2 ) button. The TV mount will automatically adjust to saved memory locations 1 or 2.
RETRACT TO LOWERED (DEFAULT) POSITION
To fully lower the mount into the cabinet, press the OK button. Press the OK button again to stop the
movement if needed.
1. Use a thin tool (such as a paperclip) to press the small button on the front of the mount’s
control unit. The control unit will beep once.
2. Press the SET button on the replacement remote. The control unit will beep repeatedly
for 10 seconds to indicate that the remote is being programmed to the unit. When the
beeping has stopped, the mount will be ready for operation.
REPLACING THE REMOTE CONTROL
PAIRING THE REMOTE CONTROL
Downward
Movement
Memory Button 1
Memory Button 2
Upward
Movement
Recall Memory
Position 1
Recall Memory
Position 2
Retract/Reset
BUTTON FUNCTIONS
