2
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual
and do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly, or inappropriate use.
WARNING!
When the system is powered on, you will hear a beep and the existing desktop height will be
displayed on the control panel.
Screen Lock/Unlock:
You can prevent accidental operation by holding the “M” button for 3 seconds,
placing the unit into Screen Lock Mode. The screen lock is activated when the display shows “- - -”. The
screen lock will also become active if there is no activity for over 60 seconds. To unlock the screen, press
and hold “M” for 3 seconds.
NOTE: The auto lock function may be deactivated as described in the Custom Programming Guide.
Sleep Mode
After resting for 10 minutes, the screen will turn off to prevent accidental operation. Touch the screen to
exit sleep mode and operate the desk.
Height Adjustment:
Press and hold the up or down arrow until the desk reaches the desired height.
Press and release the arrow quickly for minor adjustments.
Timer:
To set the timer, press “T”. The display will flash “0.5h” representing 30 minutes. Press “T”
repeatedly to increase 0.5 hours at a time. The maximum timer setting is 2 hours. The timer is set when
the display stops flashing and the light in the top right corner of the controller is on. When the timer has
reached the set time, a beep will sound reminding the user to adjust the working position. Once the timer
setting has expired (5 beeps), the unit’s timer is canceled. To deactivate the timer, press “T” five times or
until the current height is displayed and the light in the upper right corner is turned off.
Memory Setting:
To store a certain height in the controller’s memory, first press “M”. The letter “S-” will
be displayed. Now press “1”, “2” or “3” within five seconds to store the current height in memory. Each
number can store a different height. Once in memory, you can recall any of the three height settings
by pressing the corresponding button. Touching any button (except for “T”) will stop the automatic
adjustment
Changing between CM and INCH:
The preset measurement shown on the display is cm. If you would like
to change cm to inch, then press “T” for at least 3 seconds. The controller will beep twice when changed
to inch. Repeat to switch back from inch to cm, and the controller will beep once.
Reset Mode:
Press and hold the up and down arrows together until the desk beeps and moves to the fully
lowered position (do not release until the process is complete).
OPERATING CONTROL PANEL
ELECTRICAL SAFETY INSTRUCTIONS
•
DO NOT CLEAN PRODUCT WHILE POWER IS CONNECTED.
•
DO NOT DISASSEMBLE OR REPLACE COMPONENTS WHILE POWER IS CONNECTED.
•
NEVER OPERATE THE SYSTEM WITH A DAMAGED CORD OR PLUG.
PLEASE CONTACT YOUR SELLER TO REPLACE DAMAGED PARTS.
•
NEVER OPERATE SYSTEM IN DAMP ENVIRONMENTS OR IF ANY
ELECTRICAL COMPONENTS HAVE MADE CONTACT WITH LIQUIDS.
•
ALTERATIONS OF THE GIVEN POWER UNIT ARE NOT ALLOWED.
•
OUTDOOR USE IS PROHIBITED.
THIS PRODUCT IS POWERED BY ELECTRICITY. IN ORDER TO AVOID BURNS, FIRE AND
ELECTRIC SHOCK, PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY.
E01/E07 Troubleshooting
The system has experienced unusual
electrical problems. Disconnect the
power first, then wait for 30 seconds
(until the display stays off) and
reconnect.
2
1
Downward
movement
Upward
movement
Memory 1 / 2 / 3
Memory
/Screen lock
(unlock)
Timer
Display
Indica tor
light
1
2 3
TROUBLESHOOTING
