Downward
movement
Upward
movement
Memory 1 / 2 / 3
Memory
/Screen lock
(unlock)
Timer
Display
2
Operating Controller
1
Installing the Control Panel
·
Attach the control panel to the underside of the desktop using
screws as shown.
·
Tighten all screws.
·
Once the controller is installed, thread the control cable through
the cable clips.
Operation Instruction:
1.
When the system is powered on
, you will hear a beep and the existing desktop height will be displayed on
the controller.
2. Reset Mode
While the unit is powered on, press the“ ” button until the desk moves into a fully lowered position and
either “ER1”,“
63.0
”, “
65.0
”
or
“
73.0
” is displayed on the controller. Again, press the “ ” button until “RST” is
displayed on the controller. Once the display shows “
62.0
”, “
63.0
”
or
“
72.5
”, release the “
” button
—
the desk
will move upward for approximately 5mm and automatically come to a stop. After finishing the reset, the
controller should display “
63.0
”, “
65.0
”
or
“
73.0
” which is the current height.
3.
Upward movement
Downward movement
Touch the “ ” or “ ” and do not release until the desk reaches the desired height.
4. Memory Mode
To store a certain height in the controller’s memory, first touch “ ”. The letter “
S
-” will be displayed. Now
touch “ ”, “ ”, or “ ” within five seconds to store the current height in memory. The “ ”, “ ”, or “ ”
buttons can each store a different height. Once in memory, you can select any of the 3 height settings found in
the controller’s memory by pressing the corresponding button. Touching any buttons (except for “T”) will stop
the automatic adjustment.
