5. Timer Reminder Mode
To set the reminder timer, press “ ” found on the controller. The display will flash “0.5h” representing 30
minutes. Press the “ ” repetitively to increase 0.5 hours (30 minutes) at a time. The maximum timer setting
is two hours. The timer is set when the digit stops flashing and the light in the top right corner of the
controller is on. When the timer has reached the set time, a beep will sound, reminding the user to adjust
his/her working position. Once a timer setting has expired, the unit’s timer is cancelled. To de-activate the
timer, press the “ ” five times until the current height is displayed and the light found in the upper right side
of the controller is off.
6. Screensaver Mode
You can prevent accidental operation by pressing and holding the “ ” button for 3 seconds, placing the unit
into Screensaver Mode. The screensaver is activated when the display shows “ - - - ”. The Screensaver Mode
will also become active should there be no activity over 90 seconds. To turn off the screensaver, touch and
hold the “ ” button for 3 seconds.
7. Power-saving Mode
When no actions are made for over 10 minutes, the system will enter power-saving mode. Touch any button
to enter operation mode.
8. Switch measurement between cm and inch
The preset measurement shown on the display is cm. If you would like to change cm to inch, please restart
the system and press the button “ ” for 8 seconds. After the buzzer beeps twice, the measurement is
successfully reset. If you would like to switch inch back to cm, please restart the system and press the button
“ ” for 8 seconds. After the buzzer beeps once, the system is successfully switched to cm measurement
again.
Installation Instruction & User Guide
Height Adjustable Desk Control Panel
ELECTRIC
Note:
“HOT” on the controller display. The system will reset and return to normal operation after approximately 18 minutes.
2. Over-current protection mode: While operating, should the load on the desk exceed rated specifications (1000N), the
system will enter into an over-current protection mode. This will protect the system from any damage. When this
happens, the desk will move downward approximately 30mm and come to a stop with the current height displayed.
3. Attention: NEVER remove or turn off the power in order to reset the unit when it is in a protective mode or “HOT” state.
4. Please reset in case two legs are different in height.
1.Self-protection function: The unit will enter protective mode should the system operate in excess of two minutes with
Description
ER1
Overload in downwards direction has occurred
and needs to be reset.
ER2
ER3
Over-heating in the controller has occurred
and needs to cool.
Motor cable connection fault.
Both legs have different heights and need to be reset.
ER4
Motor fault
ER5
Error Code
Below are the possible error codes that may be displayed on the control panel.
Trouble Shooting
Model: DESK-V102E
