Vivo DESK-V100EBY, Инструкция по эксплуатации, Страница: 15 / 20

15
CONTROLLER
Reset Mode
1. If the height of the desk is incorrect, press the down arrow until the desk moves to the fully lowered
position. Press and hold the down arrow again for at least three seconds and release. "rSt" will be
displayed.
2. If the system displays "Er1", press and hold the down arrow for more than three seconds and release.
"rSt" will be displayed.
OPERATING INSTRUCTIONS : Press the up arrow, the desk will automatically raise to the highest position.
Pressing the down arrow will automatically lower the desk to the lowest position.
Memory Mode
To store a certain height in the controller’s memory, press the 1 button for more than three seconds. "S-1"
will be displayed, indicating that the current height has been saved to the 1 button sucessfully. Repeat the
process using buttons 2,3, and 4.
Switch the Display from Centimeter to Inch
The preset measurement shown on the display is cm. If you would like to change cm to inch, press and
hold buttons 1 and 4 for more than three seconds.
Collision Avoidance Settings
Press and hold the down and up buttons together for more than three seconds to enter the Collision
Avoidance Settings Mode. Use the arrow buttons to adjust the sensitivity level. Once the sensitivity has
been selected, press the up and down arrows again for more than three seconds to save the setting.
Collision Avoidance Sensitivity Levels: 0-9
0: Turn off collision avoidance.
1-9: Level 1 is the lowest sensitivy and level 9 is the highest.
Down
Arrow
Up
Arrow
Memory
Settings
Display
Panel