Vivitek DU8395Z, Руководство пользователя

Страница: 45 / 69

DU8395Z Series DLP Projector - User Manual
UM83950922EN01
45
Color Space
This function allows you to change the corresponding color space for the input signal in most cases, the default is
Auto.
Auto The projector detects the input signal and switches to the corresponding color space automati-
cally.
YPbPr Set the color space to ITU-R BT 601.
YCbCr Set the color space to ITU-R BT 709.
RGB-PC Use the RGB color space and set the black to 0, 0, 0 RGB, while set the white to 255, 255, 255
RGB (if an 8-bit image is used).
RGB-Video Use the RGB color space and set the black to 16, 16, 16 RGB while set the white to 235, 235,
235 (if an 8-bit image is used) to correspond to the luminance value defined in the digital com -
ponent standard.
Aspect Ratio
This function allows the user to adjust the aspect ratio of the projection image by ◄ ► keys.
Overscan
Noise may appear on the edge of the projected image or image may be small than projected image, select below
option to hide the noise or extend the image.
Off
Display the original image.
Crop
Hide the edge of the image
Zoom Extend the image to fit the projected area as possible.
VGA Setup
Set the H Total, H Start, H Phase and V Start for the VGA signal by ENTER key.
Test Pattern
The built-in images are provided for installation and adjustment. You can select Test Pattern on OSD or the TEST
PATTERN hot key on the remote control to show the test pattern. Press the ◄ or ► to select pattern or press EXIT
key again to exit the test pattern. The available test pattern options are Off / Crosshatch / Color Bar / Checker Board /
H Burst / V Burst / White / Red / Green / Blue/ Black.
3D
This function is to set the 3D format and sync method. The projector detects the type of input signals and provides
relevant options for setting. Before performing 3D setting, make sure that the input signal is connected.
3D Format Off : Turn off the 3D Display Mode. When Auto, Side by Side, Top and Bottom, or Frame
Sequential is selected, the 3D Mode will be turned on. To turn off the 3D Mode, select “Off”
and press “ENTER”.
Auto : Allow the 3D format to automatically detect the formats of Frame Packing, Top and
Bottom, and Side by Side. The input signal is HDMI 1.4b 3D.
Side by Side (Half) : This option is only applicable to input signal HDMI 1.4b 3D or HDMI
signal sent by HDBaseT Transmitter.
Top and Bottom : This option is only applicable to input signal HDMI 1.4b 3D or HDMI
signal sent by HDBaseT Transmitter.
Frame Sequential : Set input format under Frame Sequential.