5
Initial Camcorder Setup
INSTALLING AND CHARGING THE BATTERY
To insert the lithium battery:
1. If the camera is inside the waterproof casing, please take it out of the casing.
2. Push the battery cover lever up, to the unlock/open position, and remove the battery cover.
See Figure 1 and 2.
3. Insert the battery into the battery compartment as shown. Make sure to place the battery
according to the correct polarity as shown inside the battery compartment. See Figure 3.
4. Close the battery cover. See Figure 4.
To charge the lithium battery:
1. Power off the camcorder.
2. Connect the included USB cable to the camcorder and connect the other end of the cable
to a power source such as a computer or included AC Adapter.
3. During the time the camcorder is charging, the LED status indicator light (blue) is on.
When the battery is fully charged the LED status indicator light turns off.
NOTE
:
While the device is charging it cannot be used to capture images.
When the camcorder is on, connecting it to a computer will not charge the device. Make sure
the camcorder is powered off when recharging.
Figure 1 Figure 2 Figure 3 Figure 4
