Installation
Use the corresponding MountingSet to install your square. All MountingSets come with
specific mounting instructions.
User manual square, page of
5
9
Step 1
Carefully remove the four screws on the cover (see photo -
green
).
! IMPORTANT:
Hold cover tightly when removing the final screw to
avoid damage from falling down.
Carefully remove the cover by lifting it towards you and place the
cover in a safe spot.
Step 2
Plug the connecting cable from the MountingSet into the square
plug contact.
! WARNING:
When inserting the square, make sure that the
connecting cable is not pinched or pulled, as this may damage the
cable.
! WARNING:
If a power supply is located close to the square, please
connect the protective grounding wire (
yellow
) to the protective
conductor of the power supply (for example InWall MountingSet).
Step 3
The various fastening points for the square are easily identifiable
(
red
). Using the screws included in the MountingSet, fasten the
square.
! IMPORTANT:
Please follow the instructions included with the
MountingSet.
Step 4
Place the cover on the square. The correct positioning is dictated by
the button. Thread the cover into place there. Fasten the cover with
the four screws and put the upper and lower inlays in place.
