Vivax BS-300, Инструкции по эксплуатации

Страница: 60 / 76

ENG
VIVAX
PAIRING A BLUETOOTH DEVICE
1. Press BLUETOOTH ( BT ) button to turn on your Bluetooth mode.
2. Press BT PAIR (PAIR) . to enter into Bluetooth Pairing mode.
3. The display “ bt ” will flash for a few of seconds and you will heard notification signal. This
means that unit is ready for Bluetooth connection.
4. Activate the Bluetooth of the external BT device (e.g. Smartphone, Tablet etc...)
5. Enter the “ Bluetooth setting ” and make available “ Scan the Bluetooth device ”
command. After being scanned, names of “ VIVAX BS-300 ”will be listed in the list of
available devices for pairing.
6. Choose the “ VIVAX BS-300 " Bluetooth device and units will be automatically paired in
the next several seconds. The sound speaker will release a short sound notification.
The display “
bt ” stop flash, It indicates that Bluetooth has been successfully connected.
Generally, it takes only a several seconds to complete the Bluetooth connection. Could
be happen that your device will need longer time, depends to the different Bluetooth
technology (some devices might require to feed matching PIN “
1234 ” or “ 0000 ” before
connecting successfully )
Bluetooth automatical re-connection
After the renewal startup, the Sound Speaker will automatically search and connect the Bluetooth
device connected last time. Please, put these two Bluetooth devices at the mutually-discernable
distance.
If the re-connection fails, the display will show flashing “
bt ” and it will search for the Bluetooth
device again.
Bluetooth Disconnection
Press BT PAIR (PAIR) button, the Bluetooth will be disconnected , then the display “ bt ” will flash ,
entering the status of Bluetooth-searching .
Note: Maximum range will be achieved when using devices with Bluetooth version 4.0 or higher.
PLAY BACK AUDIO TRACKS IN BLUETOOTH MODE
1. Press the PLAY/PAUSE
►||
button to playbyck or pause the track, the LCD display will
lit when playback is active and flash when track is paused.
2.
►►
| / CH+ : Press button quickly to select next audio track.
3.
|◄◄
/
CH- : Press button quickly to select previous audio track.
AUX IN
This Sound Speaker is designed to connect the external audio source by the Audio AUX cable with
3.5mm plug.
1. Insert the 3,5mm Audio cable into AUX IN socket and into Eheadphone input on the
External device.
2. Press the AUX Button to enter into Aux in mode.
3. Adjust Voulume by Master Volume knob and Volume buttons on External Audio device.
Remark : In AUX IN mode, function buttons as Audio track select, Start Playback/Pause etc doesn’t
work