A&P Electronic Trading Company Limited
Website: www.vivant.com.hk
Service Hotline: 3622 1273
E-mail: [email protected]
3
−
The standard shelves are designed for Bordeaux bottle storage. The maximum loading capacity may vary
subject to the different size or dimension of the wine bottles you store, as well as the shelves quantity
pre-installed in the wine cooler.
−
To prevent damaging the door and the door gasket, make sure to have the door open fully all the way before
pulling out the shelves.
Please be careful and pull softly to avoid dropping of bottles.
−
Should the wine cooler be left empty for a long period please unplug and clean the appliance, then leave the
door ajar to allow air to circulate inside the cabinet in order to avoid condensation, mold or odours forming.
−
Locate the wine cellar away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources will increase electrical consumption.
−
Extreme cold ambient temperatures may also cause the unit not to perform properly.
When the ambient
(room) temperature is below 5°C, please unplug the cellar to avoid freezing the wine.
−
Avoid locating the unit in moist areas.
−
The appliance should always be plugged into its own individual electrical outlet which has a voltage rating that
matches the rating label on the appliance.
−
If the appliance is going to be used in an area or if your city / country is prone to power surges / outages; it is
suggested that you use a power surge protector for all electrical devices / appliances you use. The surge
protector that you select must have a surge block high enough to protect the appliance it is connected to. If
you have any questions regarding the type and size of surge protector needed contact a licensed electrician in
your area. Damages due to power surges are not considered a manufacturer covered defect and will void your
product warranty.
OPERATING YOUR WINE CELLAR
It is recommended you install the wine cellar in a place where the ambient temperature is between 19ºC-24ºC
(66ºF-75ºF), and humidity is under 60%. If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected. Placing your unit in extreme cold or hot conditions
may cause interior temperatures to fluctuate. Maintain a minimum 20mm between bottle and back plate
Control Panel and Setting
RUN
F
C
F
C
SET CHAMBER
CHAMBER
POWER
C/ F
l
The digital tube on the control panel indicates the temperature, the left tube indicates the setting temperature
and the span is 5C~22C; the right one indicates the temperature of inner cabinet and the temperature range
is 0~37C. “HH” when temperature is above 37C means the temperature is beyond the displaying span.
