VPO10
PROFIBUS TO ANALOG/DISCRETE OUTPUT CONVERTER INSTALLATION, OPERATION, CONFIGURATION AND MAINTENANCE MANUAL
______________________________________________________________________________________________________________________________
21
LCD Config -
Here the LCD display is configured for up to 3 variables: Monit 1, Monit 2 and Monit 3.
• Monit x -
In these menus user can configure the Function Block (Physical, Transducer 1, Transducer
2, Transducer 3, Analog Output 1, Analog Output 2 or Analog Output 3), Relative Index (Target Mode,
Primary Value or User Index) Structure Element, Mnemonic, decimal point (1, 2, 3 or 4) and the
alphanumeric field is enabled or disabled.
• User Prmt -
In this menu user can configure the Function Block (Physical, Transducer 1, Transducer
2, Transducer 3, Analog Output 1, Analog Output 2 or Analog Output 3), Relative Index (User Index) is
selected here, corresponding to the parameter to be displayed, Structure Element, Mnemonic and the
decimal point (1, 2, 3 or 4).
• LCD Switch -
This selects how many parameters to switch on the LCD (1, 2 or 3).
• LCD Bargraph -
In this menu the bargraph of the display is enabled or disabled.
Factory -
The following settings are possible in this menu:
• GSD -
in this parameter the identification of the GSD file (Profile Specific or Manufacturer Specific) is
selected,
• Reset -
Factory Reset - this parameter allows the device to be reset by the user. Several levels of
reboots are possible.
o
Factory Reset Parameters -
This parameter resets the machine to default values, it works as a
factory default.
o
Warm Startup -
This parameter resets the machine to the latest values in its memory.
o
Factory Reset Address -
Starts the device with address 126.
Backup Restore TRD1/TRD2/TRD 3 -
Through this menu user can restore the following data from the
Transducer Blocks:
• Initial Value -
Restores the initial value.
• Restore Factory Calibration -
Restores factory calibration.
• Restore Trd Blk Default Data -
Restores the default data of the transducer block.
• Save Factory Calibration -
Saves Factory Calibration.
Observe -
In this menu the values of the parameters of the TRD blocks (TRD 1, TRD 2 or TRD 3) are
monitored.
