VITO VIRE23022A, Инструкция по эксплуатации

Страница: 33 / 52

33
Starting and stopping the angle grinder
1. Before plugging in the power cord (11), make sure
the ON/OFF
switch (12) is in the “OFF” position;
2. Hold the angle grinder with both hands, one hand on
the handle (10) and the other on the auxiliary handle
(13);
3. Push down the ON/OFF switch lock-on button/safety
tab and then the "ON/OFF" switch;
4. For continuous operation, push down the ON/OFF
switch lock-on button/safety tab to keep the switch
locked;
5. To switch off the angle grinder, press the "ON/OFF"
switch;
Handle rotation
The handle on the angle grinder can rotate 45 ˚ /90˚ to
the left or the right for ease of operation and reduce the
fatigue.
Do not press the ON/OFF switch during this process.
Proceed as follows:
▪
Release the handle by pressing the handle rotation
button (9);
▪
Turn the handle until the button locks;
▪
When the handle is secured in its new position, you
can then press the switch (12) again.
Spindle lock
Never press the spindle lock button while
operating the appliance, otherwise it may cause
damage to the angle grinder;
1. Press the lock button to prevent spindle rotation or
when you install or remove accessories;
2. To unlock the rotating spindle, release the spindle
lock button;
MAINTENANCE AND CLEANING INSTRUCTIONS
The angle grinder was conceived to operate over a long
period of time with a minimum of maintenance. For a
continuous and trouble-free operation, you must
perform regular cleaning and proper maintenance
tasks.
Before inspecting, performing any maintenance or
cleaning, turn off the angle grinder and unplug the
power cord.
Carbon brush replacement
The motor will not start when the carbon brushes are
worn out. The brushes must be replaced in good time,
otherwise there will be faulty contact between the
carbon brushes and the rotor, which may cause sparks
and damage to the angle grinder. Both carbon brushes
must be replaced at the same time by two carbon
brushes with the same characteristics.
1. Loosen the fixing screws and remove the carbon
brush caps (8);
2. Lift the spring clip and remove the carbon brushes by
disconnecting the copper wire;
3. Insert the carbon brushes on the holder, connect the
copper wire and then place the spring clip over the
carbon brush;
4. Place the caps back on and fasten the screws.
Cleaning and storage
Cleaning
After each use, clean all the components of the angle
grinder. Wipe the power tool with a clean, damp cloth
or blow it with low pressure compressed air.
Careful handling protects the power tool and extends its
service life.
The power tool and its ventilation slots must be kept
clean. Clean the ventilation slots regularly or whenever
they become blocked.
Storage
When not in use, store the angle grinder in a dry, clean
place, free of corrosive smoke and out of children’s
reach.