VITO VIPL6, Инструкция по эксплуатации

Страница: 31 / 48

Before performing cleaning, adjusting, repairing and
maintenance work, switch the appliance off and unplug the
power cord. Wait for the blade to stop completely.
The electric planer does not require any additional
lubrication or maintenance. However, you must perform
regular cleaning for a continuous and trouble-free
operation.
Always keep blades clean and sharp. Properly cared blades
jam less frequently, are more easily controlled, and allow
greater efficiency during operation of the appliance.
Keep the roller and blade clean to ensure accurate cutting.
The motor will not start if the carbon brushes are worn out.
The brushes must be replaced in time, otherwise there will
be poor contact between the brushes and the rotor, which
may lead to sparks and damage to the power tool. Both
carbon brushes should be replaced at the same time by two
brushes with equal characteristics.
1. Loosen the bolt on the dust and shavings outlet nozzle
(9);
2. Remove the nozzle so as to access the carbon brushes
caps (10);
3. Unscrew and remove the carbon brush caps (10);
4. Remove the worn-out carbon brushes;
5. Install new carbon brushes;
6. Place and tighten the carbon brushes caps;
7. Fit the nozzle and tighten the bolt.
The blades can be sharpened on a bench grinder or a
sharpening stone. If there is too much unevenness or wear,
you should use a bench grinder before you use a
sharpening stone.
1. Remove the blades from the planer and place them in
the sharpening holder supplied with the appliance;
2. Sharpen the blades on a bench grinder with a fine grit
grinding wheel;
3. After sharpening the blade on the grinding wheel, use
the sharpening blade to achieve a finer finish and edge.
Ensure that the blades, at the end of the sharpening
operation, have the same length and angle.
Cleaning
After each use clean all the components of the planer and
empty the collection bag. Wipe the power tool with a clean,
damp cloth or blow it with low pressure compressed air.
The power tool and its ventilation slots must be kept
unclogged to prevent motor overheating. Clean ventilation
slots regularly or whenever they become blocked.
Careful handling protects the power tool and extends its
service life.
Storage
When not in use, store the electric planer in a dry, clean
place, free of corrosive smoke and out of children’s reach.
The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of power tools with your household
waste!
According to the European Directive 2012/19/EC on
electrical and electronic equipment waste and its
transposition into national law, power tools must be
collected separately and delivered to the collection sites
provided for this purpose.
You can get information regarding the disposal of the power
tool through the person in charge for recycling in your city.
Tel.: +351 256 248 826
E-mail: international@centrallobao.pt
Website: www.centrallobao.pt