VITO PRO-POWER VIMCC1400A, Инструкция по эксплуатации

Страница: 24 / 36

24
EN
is possible to adjust the rotation speed
according to the range associated to
each speed;
Position 1: 250 - 500 rpm
Position 2: 400 - 800 rpm
4.3 - Mixing Procedures
(fig. e)
1. Put some of the material to be
mixed in a container together with the
required amount of water;
2. Insert the mixing paddle into the
vessel and start the mixing process at
a slow speed;
3. Continue mixing, add more material,
and increase the speed until reach the
desired density;
4. After finishing, always wash the
mixing paddle;
Do not overload the stirrer with
excessive amounts of material
to mix;
5. Maintenance
and cleaning
instructions
This tool is designed to operate for long
periods of time with little maintenance.
For continuous and trouble-free
operation, you should perform proper
maintenance and regular cleaning.
Before performing any maintenance
or cleaning work, turn the tool off and
unplug the power cable.
5.1 - carBon BrusHes
rePlaceMent (fig. f)
The engine will not turn on when the
brushes are worn out. Brushes should
be replaced in good time; otherwise,
imperfect contact will occur between
the brushes and the commutator,
resulting in sparks and damage to
the equipment. Both brushes must
be replaced at the same time by two
brushes with the same characteristics.
1. Untighten the fixing screw (6) and
remove the brushes;
2. Insert new brushes;
3. Insert and tighten the fixing screws;
5.2 - cleaning and storage
cleaning
After each use, clean every component
of the machine. Rub the equipment with
a clean and damp cloth or blow it with
low pressure compressed air.
A careful handling protects the
equipment and extends its lifespan.
Keep the machine and its ventilation
openings unobstructed. Clean the
ventilation openings regularly or
whenever they get clogged.
storage
When not in use, store the winch in
a dry, clean place, free of corrosive
vapours and out of the reach of
children.
6. Protection of tHe
enVironMent
The packaging is made of
recyclable materials, which
can be disposed on local recycling
points.
never place power tools in
the domestic waste!
According to the European Directive
2012/19/CE on electrical and
electronic equipment waste and its
transposition into national law, power
tools must be collected separately
and delivered to the collection sites
provided for this purpose.
You can obtain information regarding
the disposal of the compressor through
the person in charge for the recycling
in your city.
7. custoMer serVice
Phone: 00351 256 331 080
E-mail: sat@centrallobao.pt
Website: www.centrallobao.pt