Vito Agro VIMETD7, Инструкция по эксплуатации

Страница: 42 / 76

42
Keep gasoline away from sparks, flames, heat sources
or other ignition sources. Do not smoke near gasoline
containers and tiller with gasoline in the tank, or during
the fueling process.
Refill and empty the tiller fuel tank outdoors only.
Before refueling, shut of the engine and let it cool.
The gasoline fueling process shall be carried out before
the combustion engine is switched on. While the engine
is running, it is not permitted to open the tank cap or
refuel.
Don’t overfill the fuel tank. In ord er to allow space for
fuel to expand, never add fuel above the lower edge of
the filler cap. Additionally, comply with the instructions
for use of the combustion engine.
If gasoline overflows, immediately clean any spilled fuel.
The combustion engine should only be switched on
after the surface dirty with gasoline is cleaned. Any
ignition attempt shall be avoided until the gasoline
vapors have volatilized (dry with cloth).
If the gasoline has come into contact with clothing, it
must be changed.
Clothing and protective equipment
Always wear security shoes with non-slip sole that fully
covers the foot while working. Never work barefoot or
in sandals, for example.
For maintenance and cleaning work, changing
accessories as well as transporting the appliance,
always wear tight fitting gloves.
Do not wear loose clothing or jewelry. Clothing worn
out during use of the equipment must be adequate and
tight, for example, a work boiler suit. Do not wear
scarves, ties, necklaces or other similar large pieces of
clothing.
Keep hair, clothing and gloves away from moving parts.
The rotating parts can touch or drag the hair or clothes,
causing serious injury
Tiller transport
Carry the tiller only when the engine is off. Before
moving it, stop the engine and wait for the tines to stop
completely.
Always transport the equipment when the engine is
cold and without fuel.
The machine should always be loaded by two people,
respecting the transport points. Use loading ramps,
lifting devices.
For safety reasons, it is not permitted to exceed an
angle of inclination of 15° during transport and the
loading process, especially when using loading ramps.
Protect the appliance and its parts carried with
adequately dimensioned load securing devices (straps,
cables, etc.). Never transport the tiller with loose parts.
Carry the machine with a suitable trailer or on a suitable
loading surface, and not in the passenger compartment
(e.g. trunk) of a vehicle.
When transporting the machine, in force regional
legislation must be respected, in particular that
concerning the load being transported and the
transport of objects on loading surfaces.
Before you start working
Before each use, check the condition and oil level
(15W40) in the air filter cup.
Before starting the tiller, check the fuel leak
tightness system, particularly visible parts such as
tank, tank cap, flexible tube connections. In the event
of leakage or damage, do not start the combustion
engine. Have the tiller repaired by an official dealer.
Make sure that the equipment is only used by people
who are familiar with the instruction manual.
Replace defective parts as well as all other worn out and
damaged parts.