P/3
P/4
Trimming
Used for trimming temple and mustache.
1. Push the slide face upwards to open the hair trimmer, which can be
started as the shaver start (Fig 7).
Cleaning & Maintenance
To ensure a better shaving effect, the shaver must be cleaned regularly. The
easiest and most sanitary way to clean the product is to wash the shaver
head part and the whisker storeroom with water each time after using it.
Do be careful when using hot water.
Do remember to check the water is not too hot to avoid doing harm to
hands.
1. Cut off the power supply of the shaver, then unplug the charger and also
pull out the product's plug from the shaver.
2. Press on the button RELEASE (1) to open the shaver head part (2) (Fig 8).
. Clean the shaver head part and the hair storeroom for some time with hot
running water (Fig 9). Make sure the inside of both the shaver head part
and the hair storeroom has been cleaned thoroughly.
4. Wash the product's surface (Fig 10).
5. Close the shaver head part and throw off surplus water.
Do not wipe the shaver head part with a towel or paper tissues, which may
cause damages to the shaver head.
6. Open the Shaver Head Part again and remain so to dry up the product
(Fig 11).You can also use the brush included to clean the hair storeroom.
Here water should not be used.
Shaver head care (once per half a year)
1. Open the shaver head part, then pull out the shaver and remove the fixed
mount (Fig 12).
2. Clean the blade and the foil with the brush included (Fig 13).
Do not clean multiple sets of blade and foil at the same time because they
are integrated. If the blade and the foil are matched improperly due to
carelessness, it'll take a couple of weeks for the product to return to
the best shaving performance.
3. Load the shaver head and then the fixed mount back to the shaver head
part (Fig 14). Make sure the dent on the edge of the shaver head part (foil
cover) matches the bulge of the floating ring correspondingly and the bulge
of the shaver head is just inserted into the dent on the center of the foil
cover.
4. Reload the shaver head part on the shaver and then close it.
