black
3
INSTALLATION
CONNECTION
1. Turn “Dome Cover” (as shown in Figure 1) counterclockwise to the end and take it off.
2. Mark the positions of one “power and video line hole” and four “screw holes” on the
ceiling. (as shown in Figure 2 & Figure 3).
Drill a hole on the proper position of the ceiling for the power and video line to pass through.
And then screw “base” to the ceiling.
Note: Screws for installation are not supplied within the sales package. Please prepare by
yourself and use proper screws.
Suggestions:
a) For safety, please let the power and video line concealed behind the ceiling.
b) If the installation spot doesn’t allow the installation personnel to screw power and video
line hole on the ceiling, they could cut the concave edge of “base” to let the power and video
line pass through.
3. Adjust the view angle of the lens (as shown in Figure 3). Then put “dome cover” back to
the “base” and turn clockwise.
1.
DC12V Input Terminal
Connect the power terminal of the camera to a 12V DC regulated power supply.
Note: Please use the correct power adaptor, DC12V (regulated), to operate this unit. The
power tolerance of this unit is DC12V ± 10%. O¬¬ver maximum DC 12V power input will
damage this unit.
2.
Video Output Connector (VIDEO OUT)
Connect the camera video output and the monitor video input with 75Ω coaxial
cable.
Figure 1
- Dome
Cover
Figure 2
Figure 3
- 4
Screw Holes
Figure 4 -
Power
& Video Line
Hole
Содержание VTD-C13A
Страница 7: ...7 NOTES...
