Vitek VT-8240 BN, Инструкция по эксплуатации

Страница: 6 / 40

6
ENGLISH
•
Before switching the unit on, make sure that your home
mains voltage corresponds to the unit operating voltage.
•
Make sure that the operation mode switch (3) is set to
the position “
0 ”.
•
Insert the power plug into the mains socket.
•
Set the required settings of the air flow using the
switch (3):
« 0 » – the hot air brush is switched off;
« 1 » – low air flow speed and low temperature;
« 2 » – high air flow speed and high temperature;
« » – «cool» air supply
Note: During the first operation some foreign smell and a
small amount of smoke from the heating element is pos-
sible, it is normal.
•
You can move out or remove the thermal brush (8)
teeth; wind a lock of hair around the brush (8), wait a
bit and turn the tip (7) counterclockwise (the teeth will
be removed into the brush), take the brush (8) out of
the hair.
•
After the hot air brush operation is finished, switch it off
by setting the switch (3) to the «
0 » position and unplug it.
•
Wait till the hot air brush cools down.
•
To remove the attachment, press and hold the attach-
ment release button (2) and turn the attachment coun-
terclockwise.
Overheating protection
Overheating protection switches the hot air brush off if
the outgoing air is too hot. If the hot air brush is switched
off during operation, set the switch (3) to the «
0 » position,
unplug the unit and make sure that the inlets and outlets
are unblocked. Let the unit cool down for 5-10 minutes and
switch it on again. Do not block the air inlets during unit
operation and avoid getting of hair into its air inlet.
CLEANING AND CARE
The нot air brush is intended for household use only.
•
Set the switch (3) to the « 0 » position, disconnect the hot
air brush from the mains and let it cool down.
•
To remove the attachment, press and hold the attach-
ment release button (2) and turn the attachment coun-
terclockwise.
IM VT-8240_70x130.indd 6 14.12.2017 9:16:44