Vitek VT-8237, Инструкция по эксплуатации

Страница: 6 / 36

6
ENGLISH
USING THE HOT AIR BRUSH
•
Make sure that the operation mode switch (3) is set to
the position “
0 ”.
•
Insert the power plug into the mains socket.
•
Set the required settings of the air flow using the
switch (3):
« 0 » – the hot air brush is switched off;
« 1 » – low air flow speed and low temperature;
« 2 » – high air flow speed and high temperature;
« С » – «cool» air supply
Note: During the first operation some foreign smell and a
small amount of smoke from the heating element is pos-
sible, it is normal.
•
You can move out or remove the thermal brush (8)
teeth; wind a lock of hair around the brush (8), wait a
bit and turn the tip (7) counterclockwise (the teeth will
be removed into the brush), take the brush (8) out of
the hair.
•
After the hot air brush operation is finished, switch it off
by setting the switch (3) to the «
0 » position and unplug it.
•
Wait till the hot air brush cools down.
•
To remove the attachment, shift to the right and hold
down the attachment release button (2), and turn the
attachment counterclockwise.
•
Periodically straighten the cord if it gets twisted during
hairdryer operation.
Overheating protection
Overheating protection switches the hot air styler off if the
temperature of the outgoing air is above the limit. If the hot
air styler is switched off during operation, set the switch (3)
to the “
0 ” position, unplug the unit and make sure that the
inlets and outlets are not blocked. Let the unit cool down
for 5-10 minutes and switch it on again. Do not block the air
inlets during the hot air styler operation and avoid getting
hair into its air inlet (5).
CLEANING AND CARE
The нot air brush is intended for household use only.
•
Set the switch (3) to the « 0 » position, disconnect the hot
air brush from the mains and let it cool down.
IM VT-8237_70x130.indd 6 05.06.2018 17:37:44