Vitek VT-3593 BK, Инструкция по эксплуатации

Страница: 4 / 20

ENGLISH
4
•
The unit is not intended for usage
by physically or mentally disabled
persons (including children) or
by persons lacking experience or
knowledge if they are not under
supervision of a person who is
responsible for their safety or if
they are not instructed by this per-
son on the usage of the unit.
•
Never use the radio if the power
cord or the plug is damaged, if the
unit works improperly or after it
was dropped.
•
Do not attempt to repair the unit.
Do not disassemble the unit by
yourself, if any malfunction is
detected or after it was dropped,
unplug the unit and apply to any
authorized service center from
the contact address list given in
the warranty certificate and on the
website www.vitek.ru.
•
To avoid damages, transport the
unit in the original package only.
•
For environment protection do not
discard the unit with usual house-
hold waste after its service life
expiration; apply to a specialized
center for further recycling.
•
Keep the unit out of reach of chil-
dren and disabled persons.
THE UNIT IS INTENDED FOR
HOUSEHOLD USAGE ONLY
BEFORE THE FIRST USE
After unit transportation or stor-
age at low temperature keep it
for at least three hours at room
temperature before switching on.
USING THE RADIO
Battery installation
•
Open the battery compartment
lid (7) and insert 3 UM-2 batteries
(not supplied), strictly following
the polarity.
•
Close the battery compartment
lid (7).
Note:
– do not use old and new batter-
ies together or different types of
batteries;
– when the radio operation is
unstable, check the batteries and
replace them if necessary;
–
remove the batteries if you are
not planning to use the radio for
a long time.
•
Before connecting the radio to the
mains, make sure that your home
mains voltage corresponds to the
unit operating voltage.
•
If the unit is mains-supplied, insert
the power cord jack into the con-
nector (9) «AC IN» and the power
cord plug into the socket. The
batteries installed in the battery
compartment will be switched off.
•
Switch the radio on with the switch
(4) and set it for reception in the
necessary «FM/AM» range.
•
Tune to the desired radio station
using the tuning knob «TUNING».
•
To set the desired volume level, use
the volume control (3) «VOLUME».
Notes:
–
for better reception in FM range
extend antenna (5) complete-
ly and place it under the desired
angle;
IM VT-3593_105x148.indd 4 28.06.2017 15:00:01