Vitek VT-2512, Инструкция по эксплуатации

Страница: 7 / 40

ENGLISH
7
on the top of the head towards the crown
against the hair growth direction.
•
You can cut hair against and along
the hair growth direction, but keep in
mind that haircut against the growth
direction will be shorter than the hair-
cut along it.
• Use the 3 mm attachment comb (6)
and 6 mm attachment comb (7) for
very short haircut. To leave longer hair,
use the necessary 9 mm comb (8) or
12 mm attachment comb (9).
•
To leave longer hair, take hair locks
between your fingers and cut hair
using the clipper (pic. 5).
•
You can use the comb (11): lift the hair
locks and cut them above the comb
(pic. 6).
•
Always start cutting from the head
back.
•
Set the hair with the comb (11) to reveal
uneven locks.
•
Use the scissors (12) to make hair-
cut even
Step 5 – the final part
– In the final stage of haircut remove the
attachment comb from the unit, turn
the the blades of clipper towards the
hair and carefully trim hair on the tem-
ples and neck. Do not press the clipper
strongly, there is danger of injuries or
cuts when open blades come in con-
tact with skin (fig. 7).
– After finishing of hair cutting put the
protective cover (10) on the blades
(3, 4).
Cone-shaped haircut
Set the necessary attachment comb and
start cutting from the head back towards
the crown. Cut hair against hair growth
from the head front to the crown and on
the head sides (Pic. 8). To get a flat top
haircut, use the comb (11): lift the locks
and cut them along the comb. Set the
hair with the comb (11) to reveal uneven
locks.
Note: Between operations, you can hang
the clipper on the hanging loop (5) having
preliminarily switched the unit off using the
power switch (1).
CLEANING AND MAINTENANCE
Lubricating the blades
Regularly lubricate the blades with the oil
(13) supplied with the unit.
– Switch the unit off using the power
switch (1) and unplug it.
– Apply one-two drops of oil (13) on the
teeth of the blades (3, 4) and the back
side of the upper blade (4), turn the
unit on and make sure that the blades
are moving smoothly.
– Switch the unit off. Clean the excess oil
with a dry cloth.
Attention! Use only the oil supplied with
the unit.
DO NOT use vegetable oil, fat, mixture of
oil and solvents for lubrication.
Solvents will evaporate, leaving the thick
oil that may slow down the blades motion.
Cleaning of hair clipper
– Switch off and unplug the unit.
– Clean the blades from the cut hair,
using the cleaning brush (14).
– Wipe the accessories and unit body
with a slightly wet cloth, and then dry
them with a soft cloth.
– Put the protective cover (10) on the
blades (3, 4).
– Do not immerse the clipper into water
or other liquids.
– Do not use solvents or abrasives for
cleaning the unit.
STORAGE
– Before taking the unit away for storage
clean and lubricate the blades (3, 4)