Vitek VT-1849 R, Инструкция по эксплуатации, Страница: 6 / 40

6
ENGLISH
• Open the lower lid (20) of the dust container
(22), pressing the clamp (21).
• Remove accumulated dust and trash from
dust container.
Note:
–
It is recommended to clean the dust contain-
er after every using of vacuum cleaner.
–
When the dust container is full, the red indi-
cator (9) lights up. In this case it’s necessary
to clean the dust container.
Disassembling and cleaning of dust
container
•
Switch off and unplug the unit, detach the
dust container, remove dust and trash from it,
close the lower lid.
•
Pull the clamp of the upper lid (17) upwards
and open the upper lid.
•
Remove the filter (18) and clean it from dust.
•
Holding the container (8) by handle (10), take
the container flask (22) and turn it till the mark
(Pic. 7).
•
Remove and wash the flask (22), filter (18)
and separator (19) under running water.
Note: Dry all the parts thoroughly before assem-
bling the dust container.
• Install the filter (18) back to its place and
close the dust container’s upper lid (18).
• Match the ledge on the separator with a mark
on the removable flask (22) and turn the
flask till the mark .
•
Install dust container (8) back to its place.
Cleaning of filters
Keep the filters clean, because the overall per-
formance of the vacuum cleaner depends on it;
clean the filters no less than 3-4 times a year, and
more often at severe pollution.
Removing and cleaning of outlet НЕРА filter
(14)
•
Open the grid (15) by pressing the clamp.
• Remove the outlet HEPA-filter (14), wash it
under slightly warm water jet, if necessary.
Dry the filter thoroughly before installing it
back to its place.
•
Install the filter (14) back to its place and
close the grid (15).
Body of vacuum cleaner
•
Wipe the body of vacuum cleaner with a
damp cloth.
• Provide that no water gets inside the unit.
•
Never use solvents or abrasives to clean the
surface of vacuum cleaner.
Delivery set
1.
Vacuum cleaner with filters and dust con-
tainer installed – 1 pc.
2.
Flexible hose – 1 pc.
3.
Crevice nozzle – 1 pc.
4.
Small brush – 1 pc.
5.
Furniture brush – 1 pc.
6.
Instruction manual – 1 pc.
Technical specifications
Power supply: 220-240 V, ~ 50 Hz
Power consumption: 1600 W
Suction power: 300 W
Dust container capacity 3 l
The manufacturer preserves the right to change
design and specifications of the unit without a
preliminary notification.
Unit operating life is 5 years
guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
This product conforms to the EMC-
Requirements as laid down by the
Council Directive 89/336/EEC and to
the Low Voltage Regulation (73/23
EEC)
VT-1849_IM.indd 6 27.06.2012 12:43:44