Vitek VT-1699 SR, Инструкция по эксплуатации

Страница: 6 / 110

6
ENGLISH
–
Wire section marking of the MWO cord and of the extension cord should match.
–
There should be a grounding wire in the extension cord.
–
The extension cord should not hang over the edges of the table, where children can pull it.
Extension cord placing should exclude the possibility of stepping on it.
SETTING
•
Before switching on the unit, make sure that the mains voltage corresponds to the voltage speci-
fied on the unit body.
•
Make sure that all packing materials are removed from the oven cavity.
•
Do not remove the light gray plate (6) covering the wave guide, it protects the magnetron.
ATTENTION! Make sure that the unit does not have damages such as: bent or broken door, broken
or loose hinges and latches, dimples on the oven body or on the door. If there is any damage, usage
of the unit is prohibited.
•
Set the unit on the flat stable surface that will bear its weight and max. weight of the products, that
will be cooked in it. Place the unit out of the reach of children.
•
Do not place the unit in places with high moisture and temperature, and near inflammable objects.
•
Proper ventilation is needed for normal operation of the unit.
•
Install the oven keeping at least 7-8 cm of free space behind and on the sides of the oven and 30
cm above it. Do not block ventilation openings on the microwave oven body. Do not remove sup-
porting legs from the bottom of the oven.
•
Do not use the unit without the glass plate and the roller ring.
•
Make sure that the power cable does not have any damages and does not pass under the unit or
over any hot or sharp edges of furniture.
MICROWAVE OVEN ASSEMBLY
If the microwave oven was stored or transported at negative temperatures, before switching it on for
the first time, keep it at room temperature for 2-3 hours.
–
Remove the package and the accessories from the cavity.
–
Check the oven for deformations. Pay special attention to the door state. If there is any problem
do not set and do not switch the oven on.
Protective covering
Body:
if there is a protective film on the oven body, remove it carefully.
Do not remove the light gray plate (6) covering the wave guide, it protects the magnetron.
Setting the glass plate
1.
Set the glass plate support (4) in the opening located on the bottom of the working cavity.
2.
Set the roller ring (5) on the bottom of the working cavity.
3.
Carefully set the glass plate (3) on the roller ring (5), by matching ledges and grooves of the glass
plate support (4).
•
Never set the glass plate with its bottom side up.
•
Do not prevent rotation of the glass plate while operating the oven.
•
During cooking always use the glass plate and the roller ring.
•
Cookware should always be set only on the glass plate.
•
The glass plate (3) can rotate clockwise/counterclockwise. It is normal.
•
If cracks or chops appear on the glass plate, stop using the unit immediately and replace the
glass plate.
OPERATION
Before switching on the unit, make sure that the voltage of your mains corresponds to the voltage
specified on the unit.
VT-1699 belorus.indd 6 13.09.2012 11:51:52