Vitek Premium TVI VTC-IRT30-2812, Руководство пользователя

Страница: 20 / 32

Operating Instructions
: Detects and compensates the white pixels which become defective.
Once CALIBRATE is selected, the pixel calibration is initiated with lens closed
and can’t cancel.
8-4. PIXEL DEFECT
(default: OFF)
• THRESHOLD : Defines the level of detection.
Be sure to set the value so that the pixels are uniformly blinking over the entire
screen. Too low of a value will get bad results because too many pixels are
detected as bad pixels and the maximum number of pixels for compensation
will be filled by the upper area.
• SENSITIVITY : Adjusts the detection sensitivity for motion.
Higher value increases the sensitivity to detect small motion easier. Too low
of sensitivity will cause erratic detection.
• H-POS,V-POS, H-SIZE and V-SIZE :
Adjust the size and position of the detection window.
• BLOCK DISP : ON enables to display the blocks for the detected area.
• MOTION OSD : ON enables to display a text message, MOVING !!!,
• SMART MOTION ZOOM : ON enables to Automatic Zoom IN/OUT when motion
is detected and also enables MOTION OSD to ON.
Area to be zoomed in by SMART MOTION ZOOM can be set at SPECIAL>
MOTION> SMART MOTION ZOOM. Adjusting
◀
,
▶
(Joystick) for ZOOM TARGET
varies the viewing angle to be zoomed when motion occurs.Set the video left
and right and/or up and down by MIRROR/FLIP.
• STAY ZOOMING : Sets the duration time for zooming by Motion.
(See “SMART MOTION ZOOM” Section)
: MOTION can detect the changes in the motion window and displays the results
in blocks and/or a text message.
7-3. MOTION (default: OFF)
: Set the direction of video by MIRROR/FLIP before setting SMART MOTION
ZOOM. Otherwise ZOOM TARGET could be different from your intention.
CAUTION
NOTICE
: SMART MOTION ZOOM does not work at low sensitivity and B/W mode.
※
SMART MOTION ZOOM doesn’t work in low light condition and BW.
20 21