8
o)
Do not leave the wheelchair with the user close to open sources of fire.
p)
Be aware that the surface temperature of the upholstery and the frame parts may be increased
after exposure to the sun or other heat source. Furthermore, with low temperatures there is a
danger of overcooling metal parts of wheelchair. It may cause burns or frostbite parts of the
body.
q)
In order to transfer wheelchair, grab the frame. Never transfer the wheelchair by grabbing the
armrests or footrest.
r)
Never use the wheelchair as a seat for the transportation of people in cars, buses or any motor
vehicles.
s)
The wheelchair is designed for people up to 125 kg.
t)
Wheelchair must be easy to fold and to unfold. In case of problems with folding, you should
re-read the instruction or contact the manufacturer.
u)
Keep caution while moving on sloping surfaces. The maximum allowable slope angle up and
down is 5%.
v)
Brakes cannot be slow down the wheelchair during ride, You should use them only to prevent
the unintended movements.
w)
Both brakes should be properly adjusted. Incorrect setting one of the brakes, results with
blocking only one rear wheel. On large slopes, it can cause difficulty to control the rotation the
wheelchair around the wheel stopped.
x)
Regularly check the tire pressure. With too low tire pressure than recommended, the brake
performance can be significantly reduced!
y)
While reaching objects, avoid excessive leaning out the wheelchair because it can cause a fall
(to the side, front, back).
z)
In order to avoid accidental rolling off the wheelchair, always put on the brakes when the
stroller is stopped, when patient get in, get off, while changing the position.
aa)
Do not leave the patient in the wheelchair (even with turned on both brakes) on the descents,
ramps, landings, etc.
bb)
It is necessary to check after each wheel mount if wheel axle connector lock works properly.
While mounting should hear “click” of the latch. Pull strongly the wheel to check if it is
installed correctly.
cc)
Using the parking brake while driving may result with an accident with all its consequences.
dd)
After each wheelchair adjustment, it is always necessary to check the correct operation of the
brake.
ee)
Oil, grease, water or other chemicals, may cause that brakes may have reduced effectiveness.
ff)
Strength of the breaking intensity may be reduced after long exploitation of the wheelchair.
You are allowed to adjust breaks yourself. In order to do that you must loosen the screws
locking the position of the break, move the mechanism of the break towards the wheel so that
the wheel will not rotate when break will be on again (try the adjustment with the user sitting
on the wheelchair). After final adjustment secure back the mechanism with the screws.
gg)
It is extremely important to keep all wheelchairs components clean in order to maintain the
product parameters.
hh)
Storing the wheelchair in areas with very high humidity (baths, laundry, etc.) or in the open
air, also the lack of hygiene causes rapid loss of operating parameters and aesthetic of the
product.
ii)
It is unacceptable to use the wheelchair after discovering any visible or detectable damages or
when the wear of some parts may cause an accident. All the repairs need to be performed by a
skilled personnel and during the warranty period only by the manufacturer's service.
jj)
In case of wheelchair fitted with pumped wheels You should not exceed the maximum
