14
CARE AND CLEANING
To prepare your new blender for initial use, follow the
steps under Normal Cleaning, below. This will clean
the unit and break in the motor.
During your first few
uses, you may notice a slight burning odor as the
motor is primed. This is completely normal and will
dissipate quickly.
Container
Normal Cleaning:
1.
Fill the container half full with warm water and add a couple drops of liquid
dish washing detergent to the container.
2.
Snap or push the complete 2-part lid into locked position.
3.
Before you begin, look at the control panel. Make sure the On/Off switch is
Off
(
O
) and the
High/Low switch is on Low
( )
.
4.
Put the container on the motor base.
5.
Switch the On/Off Switch to On (
|
).
6.
After a few seconds, switch the High/Low switch to High
( )
. Allow the
blender to run on High speed for 30 to 60 seconds.
7.
Switch the High/Low switch to Low ( ). Switch the On/Off switch to
Off (
O
)
. Wait until the blades completely stop before removing the lid or
container from the motor base.
8.
Rinse and drain the container.
To Sanitize:
1.
Follow Normal Cleaning instructions above.
2.
Fill the container half full with water and 1 ½ teaspoons of liquid bleach.
3.
Snap or push the complete 2-part lid into locked position.
4.
Make sure the On/Off switch is in the Off position and the High/Low switch
is in the Low position. Put the container on the motor base.
5.
Switch the On/Off Switch to On (
|
).
6.
After a few seconds, switch the High/Low switch to High
( )
. Allow the
blender to run on High speed for 30 to 60 seconds.
