Follow these instructions in sequence to set the units, time and date, or
skip this section to change settings later.
1
To enter configuration mode,
press the
On/Off
button to turn on the device,
press the
Enter
button repeatedly until the time is displayed.
press the top
Recess
button and the
Down
button at the same time
to enter configuration mode.
Note that the Vitalograph micro turns itself off if not used within two minutes.
2
To set the Units
press the
Down
button to change the Thumbs Up/Down symbol to:
Thumb Up for US date format, or, Thumb Down for European data format,
press the
Enter
button to continue.
3
To set the Time,
press the
Up
or
Down
buttons to select the correct Hour,
Note that pressing continuously on a button changes the number quickly.
press the
Enter
button,
press the
Up
or
Down
buttons to select the correct Minute
press the
Enter
button to continue
4
To set the Date,
press the
Up
or
Down
buttons to select the correct Year
press the
Enter
button,
press the
Up
or
Down
buttons to select the correct Month
press the
Enter
button,
press the
Up
or
Down
buttons to select the correct Day
press the
Enter
button and when ACC and the Thumb Down symbol
is displayed press the
Enter
button again to finish.
A 9-V (e.g. PP3) disposable battery (not provided) must be installed before the Vitalograph
micro
can be used.
Note that it is recommended to remove the battery if the Vitalograph
micro
is not used for several months
1
Open the battery compartment door at the back of the unit.
2
Push the battery connector onto the battery terminals.
3
Fit the battery into the battery compartment making sure the leads are pushed into the entry cavity.
4
Close the battery compartment door.
Page 2
... installing the battery in the micro
... setting the Units, Time and Date on the micro
1
2
3
4