vita Vacumat 500, Руководство по эксплуатации, Страница: 14 / 19

VITA – Vacumat 500
39/03/04 Zahfabrik H.Rauter GmbH &Co.KG D 79704 Bad Säckingen
13
7 Utilities
All programs listed may be selected by entering the respective program number using the keyboard (BlockH).
The selection must be confirmed by pressing the "#"-Key. The programs may only be selected if no firing
program is active. To stop or cancel a program, press the "Stop"-Key
Number Program Description Display
Operating
Keys
276 + # Show Operating Hours Display in hours and minutes LCD Block A
277 + # Show Software Version displays software version LCD Block A
281 + # Stand-by temperature
Entry: 200°C - 800°C (500°C
∂
)
LCD Block B Keys
Block G + #
282 + # Set signal on program end Selection 1 = signals once
Selection 2 = continuous signal
∂
LCD Block B Pre-Drying
Key + #
283 + # program termination with
‘Stop’ Key Selection 1 = press ‘Stop’ 2x
Selection 2 = press ‘Stop’ once
∂
LCD Block B Pre-Drying
Key + #
284 + # start firing program when
temperature of firing chamber
is higher than stand-by
temperature Selection 1 = start when temp. is
higher than stand-by temperature
∂
Selection 2 = start at stand-by
temperature
LCD Block B Pre-Drying
Key + #
285 + # Set volume select ‘0’ - ‘9’ LCD Block B Keys
Block G + #
289 + # Initialization all factory-set time/date values are
read into memory (VITA settings) LCD Block B
291+ # Liftpositions:
Pre-Drying and Cool-Down Pos.1, 1st pre-drying step
Value 0 - 40
Pos.2, 2nd pre-drying step
Value 30 - 60
Pos.3, 3rd pre-drying step
Value 50 - 150
Pos.4, cool-down step
Value 30 - 120
Inv., intervall time
Value 10 - 60 sec LCD Block B input with
Block G + #
keys
select pos.
with
pre-drying
key
292 + # Lift speed select S up 0 - 99
select S down 0 - 99 lower LCD
Block B Keys Block
G + #
select using
pre-drying
key
293 + # Lift stop select L up 0 - 99
select L down 0 - 99 lower LCD
Block B Keys Block
G + #
select using
pre-drying
key
294 + # Temperature-Adjustment see description ‘Adjusting the firing
chamber temperature
0 close firing chamber without
heating Keys
Block G + #
∂
Factory settings