6
7
E. TROUBLE SHOOTING
F. TECHNICAL PARAMETERS
MODEL: SP-A3T-UP
DIMENSION: 316*360*1040mm
RATED VOLTAGE:220V~240V RATED FREQUENCY:50Hz
RATED POWER:510W HEATING POWER:420W
HOT WATER:
90
4L/h COLE WATER:
10
2L/h
≥ ℃
≤ ℃
REFRIGERANT:R134a/45g RATED CURRENT:2.3A
COLD TANK CAPACITY:2L
HOT TANK CAPACITY:1L
Water is leaking
Unplug dispenser, remove bottle and replace it.
No water is coming from the spout.
Make sure the bottle is not empty. If empty, replace it.
Make sure to completely depress the pushbutton controls.
Cold water is not cold
It takes up to one hour after setup to dispense cold water.
Make sure the power cord is properly connected to a working outlet.
Make sure the back of the dispenser is at least 20cm from a wall and
there is free airflow on all 20cm sides of the dispenser.
Make sure green power switch on back of dispenser is ON.
If water still isn’t cold, please ask for the service agent for assistance.
Hot water is not hot.
It takes 15-20 minutes after setup to dispense hot water.
Make sure the power cord is properly connected to a working outlet.
Make sure red power switch on back of dispenser in ON.
Nightlight is not working
Make sure the power cord is properly connected to a working outlet.
Make sure nightlight power switch on back of dispenser in ON.
Dispenser Is Noisy
Make sure the dispenser is positioned on a level surface.
H. CLEANING
G. CIRCUIT DIAGRAM
T
2
Control
panel
L
N
PE
S
5
S
4
S
3
W
a
ter
pump
S
2
T
3
S
1
comp
Heater
T
1
2. Rinsing instruction:
Rinsing instruction:
Put the pumping pipe into the bottle.
Stop the bottle.
Push the bottle into the water drinking machine and close the door.
Turn on the power; let the machine pumped water then press the outlet
button.
Turn off the power and remove the water bottle.
Open the drain plug in back of the machine.
Screw up the drain plug after water drained and you can use the machine.
3. Draining instruction:
Draining instruction:
Open the hot water tap.
Open the outlet in back of the machine and drain the water.
After draining, cover the outlet and you can use the machine.
(Attention
The drained water may be very hot, please operate it carefully.)
：
4. Sanitizing:
Sanitizing:
Generally sanitizing should be done every 3 months (Exact time depends
on the machine working environment). About the sanitizing and cleaning
media use method please refer to the cleaning media use direction. You'd
better consult your service providers for the help.
1
2
3
4
5
6
7
1
2
3
