STEP 1
STEP 2
Attach the four wall mount standoff brackets (B) to the two upright beams (A) as shown by removing the pre-installed
acorn nuts and washers then placing the smaller side of the standoff bracket over the threaded bolts and re-installing
the washers and acorn nuts. DO NOT TIGHTEN NUTS YET.
Measure 12" from the TOP end of the upright beam to the standoff bracket as shown below then securely tighten nuts.
Measure 17-1/2" from the BOTTOM end of the upright beam to the standoff as shown below then securely tighten nuts.
Attach the top rung (C)
Lay the two upright beams on the floor 32" apart. Loosen the acorn nuts on the top rung saddles enough to
insert the first wood rung. Position this wood rung under the top saddles locating the saddle between the
laser marks on each end of the rung. DO NOT TIGHTEN YET.
Measure 8-1/2" from the TOP of the upright beam to the CENTER of the wood rung as shown below.
Securely tighten saddle nuts.
STEP 3
T
O
P
12"
Reserved for
chin up bar
Acorn Nut
Split Lock Washer
Flat Washer
Standoff Bracket
Upright Beam
T
O
P
17-1/2"
ASB3680C3
T
O
P
8-1/2"
8-1/2"
Reserved for
chin up bar
Attach the balance of rungs (C)
Once the top rung is in the correct position and securely tightened, begin attaching the rest of the rungs
working from the top to the bottom. Again, loosen the acorn nuts at each saddle enough to insert the wood
rungs. Position the wood rung under the saddles and locate the saddle between the laser marks at each
end of each rung. DO NOT TIGHTEN YET. Use the supplied wood spacer block to evenly space the
balance of the rungs by placing this spacer between the rungs as shown above. Once you have the rungs
spaced out you can then securely tighten the saddle nuts. Note: These instructions are for evenly spaced
rungs (8-1/2" center spacing) you can space the rungs to your desired location if you prefer.
Laser Marks
Standoff Bracket
Saddle
Spacer Block
Place the spacer block at both sides
when tightening saddle nuts.
Spacer Block
