Cleaning:
Switches may become sticky from use. Unplug the machine and use a wet cloth,
moistened with water and a mild detergent, to clean around the edges of the switch paddles until
they function freely. Work the switches back and forth a few times to loosen any dried residue under
switch. Leaving switches sticky will damage or burn out the switches. Clean carefully, using caution
not to allow water or other liquids to infiltrate the switch.
Start/Stop Switch:
Stop a program mid-cycle with the START/STOP switch, not the ON/OFF switch.
If the ON/OFF switch was used, wait 30 seconds for power to recycle and the timer to reset before
resuming operation.
4
BarBoss
®
Advance &
Drink Machine Advance
ON/OFF Switch.
Located on the front of the
machine below the control panel, the ON/OFF switch
controls the power to the machine. While plugged in,
switch to ON to ready the machine for blending.
Shut OFF the power switch at night or whenever the
machine will be left unattended.
START/STOP Switch.
This is a lighted switch. When
light is lit, power is ON. Depress START switch
to activate program setting and again to stop a
program mid-blending cycle.
During operation, you may interrupt a program by
pressing the START/STOP switch.
PROGRAM DIAL.
Allows user to select a number
of pre-programmed settings. Blender will shut off
automatically at the end of the program. Program
is activated only when the power switch is ON. See
page 9 for programming details.
PULSE Switch.
The PULSE switch can be used to
quickly refresh product in the container by
depressing the switch and holding down as long
as needed. The pulse switch can only be used
when the power switch is ON.
IMPORTANT NOTES!
