THREE PRONG
ADAPTERS ARE NOT TO
BE USED IN CANADA.
10
11
lending Tips
1. If your recipe freezes up, try reducing the amount of ice. Compared
to other blenders, you do not need as much ice to make an equally
frozen drink in a Touch and Go
TM
Blending Station.
®
2. Place liquids and soft foods in your container first. Hard items and ice
should be placed last.
3. Whole, hard or frozen ingredients should be small. Solid frozen fruit is
extremely difficult to blend. For best results use semi-frozen fruit. Using
same size batches of semi-frozen fruit and ice will keep your drinks
consistent. If you notice chunks, reevaluate the batch size.
4. When creating recipes, always allow for enough liquid to ease the
blending process. For recipes with minimal liquid, use the SPEED
CONTROL buttons to run the machine on its lowest settings until it is
processing smoothly. Finish blending by using one of the PRE-SET
PROGRAMS that best matches the drinks viscosity.
Maintenance Tips:
• NEVER bang the container against a surface to loosen the ingredients.
Remove the container from the base and use a rubber spatula to remove
thick mixtures from the bottom of your container.
• NEVER shake or rattle a container in use while seated on the motor base.
• NEVER remove the container before the machine has come to a
complete shop.
• NEVER start the motor before the container is in place.
The instructions appearing in this Owner’s Manual cannot cover
every possible condition and situation that may occur. Common
sense and caution must be practiced when operating and
maintaining any appliance.
B
Gasket Installation Instructions:
1. Follow the instructions on page 8 on preparing the counter area for
the installation of your In-Counter Touch and Go
TM
Blending Station
®
.
Also, use the Template Sheet (provided in your machine’s original package)
to assist you in the placement and ventilation of your machine.
2. Peel off the white paper on the back of the black In-Counter Gasket
Foam Pad to reveal the adhesive backing.
3. Place adhesive side down onto the counter being careful to match up
the gasket hole with the hole you have cut in the counter.
4. When you have matched up the holes, firmly press down on all sides
so that the gasket is firmly attached.
5. Fold flap inside the hole down towards the ground.
6. Insert your Touch and Go Blending Station inside the hole, making sure
the flap is down snug against the machine.
7. Do not secure the machine to counter with bonding materials.
This gasket was designed to protect your machine from water
damage and to reduce noise. Failure to properly install this gasket
could result in moisture damage.
I
n-Counter Gasket
FLAP
Fold down inside hole after gasket
is firmly attached to the counter.
Front
Back
GASKET HOLE
Match up with hole cut in counter.
