1. Carefully remove all parts from the box.
2. Put the card template to the desired location and mark the key hole points on the wall.
3. Remove the card template and drill holes on the wall and insert the anchors (A) into
the holes.
4. Insert the wood screws (B) to the anchors (A) and leave the threads 1/8” out.
5. Hook the fixture body (C) to the wood screws (B).
6. Install the cord cover rod (D) to the fixture body (C), then install the rod (E) to the rod (D)
and install the rod (F) to the rod (E).
7. Insert the bulb into the socket.
8. Install the shade (K) to the socket tube (J).
9. Remove the protective plug cover (H) from the plug (G).
10. Swing the arm (Y) and arm (X) to desired angle. Tighten the set screw (Q) using the
wrench (P) if needed.
11. Plug into a proper electrical outlet and test the fixture.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents
Studio Swing Arm Wall Light
Item# 82034
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
ASSEMBLY INSTRUCTIONS
US
L I
D
S E
T
M
DRY
Portable assembly
A
J
P
B
H
Q
K
C
D
E
F
G
Bulb included
Card template
X
Y
