VISTEK V1626 digital to analogue
converter
4
Issue 1
2.
INSTALLATION
2.1
Introduction
This section gives information on installing the V1626 DAC modules into the V1601 and V1603 interface
frames and details on the connections which can be made to it. Information is also supplied on the function
of each Preset adjustment and switch which are made available to the user on the front panel.
2.2
Installing Modules
The V1601 and V1603 frames are normally supplied with modules fitted. However, if further modules are to
be fitted to a part loaded unit follow the instructions below.
Rear (I/0) modules
Remove the screws from the blanking plate covering the spare position at the rear of the equipment and
remove the plate. Place the new rear module in frame and slide into the unit until the connector(s) mates.
The connector panel on the rear module should be seated flush with the rear cross extrusions of the frame
when inserted correctly. Screw the module to the rear cross extrusions with the screws provided.
Front modules
Withdraw the front panel of the frame and fold it down. Place the new front module in the card guides (take
care to insert the circuit board into the runners and not the screen plate) and slide into the frame until it
mates with the rear module. Close the front panel.
