www.vistacnc.com
- 7 -
www.vistacnc.com
- 7 -
iMach
III
P1A Pendant Manual v. 3.3
In PlugIns menu, click CONFIG
•
Step Size Selection
sets predefined step size in each dropdown window. Select NONE to skip
that window in cyclic step selection. Step size in the first window is used as the default step
size
.
•
Number in
Step Jogging
FeedRate
is the feed rate only used in MPG step jogging. When
MPG wheel stops, the feed rate and FeedRate Overridden rate (FRO) automatically changes
back to the number which was used before MPG moving. Set 0 to use current FeedRate and
FRO rate in the system.
•
Numbers in
Step /Vel Mode Switch Sensitivity
is set to adjust the sensitivity of mode change
from STEP to VELOCITY. The smaller the number, the less turns are needed to change to
VELOCITY mode.
•
Numbers in
Speed Change Sensitivity
is set to adjust the speed change sensitivity in V mode.
The smaller the number, the less turns are needed to reach maximum axis speed.
•
Steps to Delay Start
is used to set the number of steps to delay to start axis movement. In C
mode, axis starts to move only after that many numbers of steps are turned from MPG wheel.
SPECIFICATIONS
Work with Mach3 R2.63 and above.
100 steps (clicks) per Rev MPG.
MPG MTBF > 10000 hour.
Shipped with10' High Speed USB cable. Extendable to 15’ with extension cable, and to 45’
with USB hub cables.
Size (over all) 6.1"(L) x 3.1"(W) X 2.7"(H)
