8
2.2 Connection
•
Micro SD memory slot on the Bottom Board
Remove the cap at buttom of the camera to insert the SD memory card.
•
Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally
a cross-over cable is used for directly connection to PC, while a direct cable is used for
connection to a hub. You can also use a router featuring PoE (Power over Ethernet) to
supply power to the camera.
•
Connecting Alarms
AI(Alarm In):
You can use external devices to signal the network camera to react on
events. Mechanical or electrical switches can be wired to the AI (Alarm In) and G
(Ground) connectors.
G(Ground):
Connect the ground side of the alarm input and/or alarm output to the G
(Ground) connector.
AO(Alarm Out):
The network camera can activate external devices such as buzzers or
lights. Connect the device to the AO (Alarm Out) and G (Ground) connectors.
•
Connecting the Power
Connect the power of 12 VDC 450mA for the network camera. Connect the positive
(+) pole to the
‘+’ position and the negative (-) pole to the ‘-’ position for the DC power.
–
Be careful not to reverse the polarity when connecting the power cable.
–
A router featuring PoE (Power over Ethernet) can also be used to supply power to
the camera.
–
For the power specifications, refer to the Appendix, Product Specification.
–
If PoE and 12 VDC are both applied, the camera will be supplied with power from
PoE.
•
Connecting Audio
Connect Speaker to Audio line output and external Mic to Audio input line.
