Vista VK2-108VRDIR35V16e, Быстрое руководство

Страница: 16 / 20

16
Resetting to the factory default settings
To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in “System > Maintenance” of Users Manual) or use the
Reset button on the network camera inside the bottom cap.
• Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings using the
Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Open the cap.
3. Press and hold the Reset button with a straightened paperclip while reconnecting
the power.
4. Keep the Reset button pressed until the Status indicator blink.
5. Release the Reset button.
6. When the Power Indicator changes to Green (may take up to 40 seconds), the
process is complete and the network video camera has been reset.
7. The network camera resets to factory defaults and restarts after completing the
factory reset.
8. Close the bottom cap tightly to ensure waterproof.
CAUTION:
When performing a Factory Reset, you will lose any settings that have been saved.
(Default IP 192.168.30.220)