Installation Guide
8
Connect the wiring
Feed the pre-connected main lead (that feeds into the connections E3 and E4) through the
appropriate point and connect it to your video out and power in cables. A service jack
socket is also provided for temporary video connection when focusing the camera, using an
optional service cable( VFD/VIRD/LEAD).
Adjust the camera position
You can adjust the focusing position by
rotating and panning the camera base (see
fig.
right
).
Install the camera liner
Carefully fit the camera liner (E1) over the
camera base so that it snaps into place as
shown in section
E
and does not obstruct
the camera lens.
Replace the dome cover
Replace the dome cover (E2) and rotate to
close it as shown in section
E
.
Insert/Withdraw miniSD memory card
It is not necessary to fully remove the dome lid to gain access to the miniSD card.
To insert or remove the miniSD card, turn the dome lid anti-clockwise until the first detent is
reached. depress and release the card to eject it. When inserting the card, press until a
click is felt and then release. the card will be retained in the slot.
When complete, turn the dome lid clockwise and re-insert the security screw (G1) if
necessary.
Complete the installation
Use the supplied T6 screw (G1) to secure the whole enclosure (see section
G
)
4.
5.
6.
7.
8.
9.
Rotate and pan
the camera base
to the required
position.
Service
Jack
