Vista SmartDisc 10IP, Руководство по установке

Страница: 33 / 74

3 System description
32 Vista SmartDisc 10IP
3.9 Device reset
The following method allows you to revert to SmartDisc 10IP factory set-
tings. This reset is a full device reset, reactivating factory settings. All settings,
including passwords and user names, will be deleted.
Deleting user names
and passwords
If you want to delete only user names and passwords, use the Reset push-
button described in chapter "Control, indicators, and ports". (see “Controls,
indicators, and ports” on page 15)
The steps
one by one
■ Switch the SmartDisc 10IP off.
■
You need a 9 pin Sub-D plug with pin 2 connected to pin 3, and pin 7
connected to pin 8.
■
Plug this reset plug into the interface labelled "Transp. data/Control
interface" (see “Pin assignment and functionality” on page 19) .
■
Switch the SmartDisc 10IP unit on and wait until LED Power on the front
starts flashing.
■
Remove the reset plug.
■
Your SmartDisc 10IP unit will be ready again as soon as device reset and
re-initialisation have been completed.
Pin assignment of
RS-232 interface
Transp. data/Control interface
Connector end view / 9 pin
Sub-D socket
All recordings and the log file of a removable hard disk in the frame during reset
will be deleted. The removable hard disk will be reformatted. To keep recordings
and storage settings, remove the hard disk before
Device reset
of your
SmartDisc 10IP
.