Vista, Norbain SDL Limited, Norbain House, Eskdale Road, Winnersh Triangle, Wokingham, Berkshire RG41 5TS
HB-VVFLV-1
Issue 1 10/03
INSTALLATION
Mounting
Two 1/4 20 UNC mounting points are provided for mounting the camera, one on the top of the case and one on the bottom of the
case. Mount the supplied camera bracket in the desired postion using the correct fixings for the surface. The camera is supplied
with two fixing screws. Once the bracket is fixed, mount the camera and point it at the desired scene. Once the camera is viewing
the correct scene, it should be locked into position with the bracket locking screws.
Power Connection
The camera should be powered using the 12V DC power supply unit provided. Observe the correct polarity when connecting the
power, as indicated on the rear of the camera.
To avoid possible short circuits, the power should remain off until all required connections have been made.
Lens Level Adustment
When setting the lens level, the AGC funtion (SW1) should be switched
OFF
. The lens level potentiometer is used to vary the DC
reference voltage controlling the lens. The potentiometer has the effect of increasing or decreasing the lens aperture and should
be adjusted to obtain a 1V pk-pk setting. When making adjustments, it is best to start with the potentiometer set fully clockwise so
that the video signal is overexposed, then, gradually decrease the level until the setting is correct.
When the lens level is set correctly, the AGC function can be switched
ON
.
Focusing
The camera back-focus is pre set to a position that allows optimum performance through the lens focal range.
The lens adjustment levers are located under the camera lens cover. Remove the cover by pushing down gently and sliding it in
the direction indicated by the arrow on the cover itself. To adjust the lens, loosen and then adjust the T-W lens lever to produce the
desired angle of view for the scene. Tighten the lever once adjustment is complete.
Whilst setting the angle of view, it may also be necessary to make primary focus adjustments. To do this, loosen and then adjust
the
¥
-N focus lever until the sharpest possible image for the area of interest is achieved. Tighten the lever once focus adjustment
is complete.
CONFIGURATION
On the rear of the camera, there are two configuration switches:
BLC on/off
The BLC (Back Light Compensation) facility compensates for back-lit scenes by enhancing the exposure of objects within the BLC
sampling area (see figure below). These objects would previously have been in silhouette. Select
ON
or
OFF
using the BLC switch
(SW2). Default is
OFF
.
AGC on/off
The AGC (Automatic Gain Control) facility can improve picture quality when levels of illumination are low. Select
ON
or
OFF
using the
AGC switch (SW1). For most applications, the AGC facility should be
ON
and is therefore the default setting.
SPECIFICATIONS
Option
Mono
Colour
Resolution (TVL)
Sensitivity (lux @ f1.2)
CCD Sensor size
Scanning system PAL
Scanning system CCIR
Automatic Gain Control (AGC) on/off
Digital Signal Processing (DSP)
Auto White Balance
Backlight Compensation (BLC) on/off
Integrated Direct Drive Auto-Iris Lens
Supply
12 VDC +15%, -10%
N
C
D
6
3
5
C
K
e
N
C
D
7
3
5
C
K
e
N
C
L
6
3
5
C
K
e
N
C
L
7
3
5
C
K
e
380
1/3”
0.1 0.2 1.0 1.2
570
1/3”
330 470
1/3” 1/3”
Internal Synchronisation
ON
1 2
+
52.7
52.7
112.8
BLC SAMPLING AREA