6
Xero 4
1.2
1.3
1.5
1.9
1.9
1.1
1.2
1.1
1.3
Separating tape
1/2019 (US)
Layout information can be found on the drawing 320-143.
1.1 Insert profile end caps 981-479.05 on top and on bottom
1.2 The cross-connections are fixed to the side of the sytem uprights using two M6 x
12
/0.472" thread grooving screws —> do not overtighten
screws!
1.3 The bracket of the wall attachment kit is attached to the side of the system uprights using two M6 x
12
/0.472" thread grooving screws —> do not
overtighten screws! At least 2 brackets are required per upright - the number depends on the condition of the wall.
1.4 Assemble the uprights into single unit.
1.5 Set up unit, and ensure that it is perfectly aligned in height and that it is perpendicular.
1.6 Mark mounting points.
1.7 Drill holes in wall and insert dowels.
1.8 Reposition wall unit and screw into place. Proceed as described in point 1.5.
1.9 Important: Wind separating tape smoothly around the profile (we recommend: Knauf Trenn-fix 65)
The wall uprights must be screwed to the wall with at least 2 Ø
6 mm
/0.236“ screws. The wall and its fixtures must be capable of taking a
min. fraction weight of 1.6 kN. Please observe the instructions supplied by the dowel manufacturer.
Assembly in plasterboard
1. Assembling wall upright
Please observe the indications concerning weight loads and ensure that the substructure of the wall units/furniture and their fixtures can
support the expected loads.
