2
D-302415
4. ENROLLMENT
Refer to the PowerMaster-10 Installer Guide for the device enrollment procedure.
5. CONFIGURATION AND OPERATION
5.1 Service Messages
Five kinds of event codes are automatically included in a service
transmission in addition to the repeater’s:
O
AC fail
O
Low Battery
O
End of life
O
Tamper
O
Supervision.
Upon power failure, recharging stops and the backup battery takes
over. It is therefore correct to assume that without power input the
battery is gradually weakening and may be reported as “low”.
Power / battery restore
is reported only in the following test report.
End of life
is reported when battery power is depleted and device is
about to shut down.
Tamper restore
is reported immediately upon occurrence.
If the
tamper
or
power failure
condition persists long enough,
respective alerts will be sent out again with each test report.
B
C
D
A
E
F
A.
Siren.
B.
Motion detector.
C.
Door or window open/close detector
D.
Keyfob
E.
RP-610 PG2 Repeater
F.
PowerMaster-10 Control Panel
Figure 3: Repeater Configuration
6. MAINTENANCE
Note:
Battery replacement should be done by a service man.
B
C
D
A
E
F
H
G
A.
Turn & push battery
B.
Battery pack connector
C.
Connect the wires to the terminal block
D.
Self-Test button
E.
Enroll button
F.
AC connector terminal block
G.
Battery cable
H.
Battery
Figure 4 - Battery Pack Insertion
