Chapter 8: Data
DE5450S Remote Programmer Guide Rev. 8
59
1. Check
the
Send updated data immediately
field, to automatically
update changed settings from the Remote Programmer to the control
panel.
Note:
If the above field is not checked, the control panel will only be
updated when performing download table or full download.
2. In
the
Delay after acknowledge during download
field, enter a time
value (in milliseconds) for a delay in sending commands. This field
should be used when problems in communication is experienced.
3. In
the
Download Code
field, if a value (four hexadecimal digits) is
entered, the Remote Programmer uses this value instead of the value in
the site information field when performing login.
Note:
If no value is entered in this field, then login is performed using the
download code in the site information table.
Note:
For additional use of the download code see Chapter 9: Two
Download codes.
8.2 Using Customized Full Upload/Download Data
Note:
The following section applies to P only.
This feature enables selecting only specific data to be uploaded/downloaded in
connection with the control panel. This saves significant time in
uploading/downloading data.
1. Check
the
Enable customizing Full Upload/Download Data
field, to
enable uploading/downloading of customized settings.
2.
Mark the relevant check boxes to specify the data to be uploaded to the
control panel.
Attention:
Use the exact same customized fields for both uploading and
downloading in order to prevent inconsistency in the data.
Note:
Click the
Next/Prev
buttons to see all the available fields.
Note:
When X-10 Device Settings and PGM are selected, the scheduler
becomes functional (see chapter 6, for further details).